I have a similar problem. I am using Windows version, and whenever I use the elog client to send entry, it will not take with MOptions set. I usually have 2 attributes required (both MOptions), and I get the message that it is missing a required attribute. When I use ROptions, or Options, it works fine. Is there a problem with MOptions, or am I perhaps using a badly formatted commandline?
Commandline as follows: C:\elog>elog -h IP_ADR -p 80 -l gbld -u username password -a Type=Other -a Operator=SCADA -a Category=Controls -a Subject=Alarm "Please ignore."
Type and Category are required and MOptions.
Below is the pertinent part of the config file:
;***** Attribute Section
Attributes = Log Date, Operator, Type, Category, Engine, Work Order #, EPN, Fuel Tank 1 (A&B), Fuel Tank 2 (C&D), Engine Hours Stop, Engine Hours Start, Email To, Subject
Comment EPN = (Equipment Piece Number)
Comment Fuel Tank 1 (A&B) = (West)
Comment Fuel Tank 2 (C&D) = (East)
MOptions Type = Alarm, Trouble, ESP, Haz. Wx.,Problem, PM, Routine, Load Test, Other
MOptions Category = Engine, Generator, Controls, Fuel, Oil, HV Switchgear, MLG&W, Other
Options Engine = All, 1A, 2A, 3A, 4A, 5A, 1B, 2B, 3B, 4B, 5B, 1C, 2C, 3C, 4C, 5C, 1D, 2D, 3D, 4D, 5D, A Bus, B Bus, C Bus, D Bus, A&B Busses, C&D Busses, West Gen (001), East Gen (002)
Required Attributes = Type, Category, Subject
If time permits, I would appreciate any help possible.
BTW, I like the additional elcode. |
| Chris Green wrote: | | 1) With the configuration below, I can't set the Author attribute to be the author of the reply. As written, it gives the Author field as blank. If the Remove on Reply line is removed, it is set to the parent's author. What am I doing wrong? |
Hey, elog made it to MiniBooNE! I'm working on MEG...
What you need is the following:Preset on reply subject = Re: $subject
Preset Author = $long_name
Preset on Reply Author = $long_name
Locked Attributes = Author
The Subst statements work after the entry gets submitted, while the preset statements work before. So Preset on Reply <attribute> is what you need.
| Chris Green wrote: | | 2) With the Page Title line set as shown, $logbook gets expanded as "Charged+Current+Pi+Plus". If the line is left blank, the correct "Charged Current Pi Plus" gets put in the title line. |
The substitution $logbook originally produces a valid URL to the logbook, and thus replaces blanks by "+". I changed that so that $logbook produces the original name containing blanks, and $elogbook is the encoded one with the "+"'s. The change is in revision 1.723 |