DRS4 Forum
  DRS4 Discussion Forum  Not logged in ELOG logo
Entry  Tue Oct 7 14:09:02 2014, Stephane Debieux, USB Microcontroller firmware 
    Reply  Mon Oct 13 16:46:56 2014, Stefan Ritt, USB Microcontroller firmware 
       Reply  Mon Oct 13 17:08:40 2014, Stephane Debieux, USB Microcontroller firmware 
          Reply  Mon Oct 13 17:14:58 2014, Stefan Ritt, USB Microcontroller firmware 
             Reply  Tue Oct 14 16:21:07 2014, Stephane Debieux, USB Microcontroller firmware 
                Reply  Tue Oct 14 16:29:12 2014, Stefan Ritt, USB Microcontroller firmware 
                   Reply  Tue Oct 14 16:34:45 2014, Stephane Debieux, USB Microcontroller firmware 
                      Reply  Tue Oct 14 16:38:14 2014, Stefan Ritt, USB Microcontroller firmware 
                         Reply  Tue Oct 14 16:51:37 2014, Stephane Debieux, USB Microcontroller firmware 
Message ID: 379     Entry time: Mon Oct 13 17:08:40 2014     In reply to: 378     Reply to this: 380
Author: Stephane Debieux 
Subject: USB Microcontroller firmware 

Stefan Ritt wrote:

Stephane Debieux wrote:

Hi,

I'm trying to recompile the USB microcontroller firmware starting from the drs_eval.c file but I'm not able to get a .iic file close to the one provided with the eval board. It seems to me that this drs_eval.iic file does not match the drs_eval.c and drs_eval.hex files or that I'm doing something wrong. Could you please help or give me an explanation.

Thank you.

Stephane

 

I did not touch the firmware since a couple of years, but I can confirm that the drs_eval.iic is the correct firmware file, since we use this one on all of our boards. To program it, you need the Cypress USB Console. You remove the jumper (to detach the EEPROM), then power the board (which then boots from the internal memory), connect to the board via the Cypress console, the put back the jumper while the board is running, then program the file into the EEPROM.

Best,
Stefan 

 Thank you Stefan.

Would that be possible to get the corresponding drs_eval.c source file since I'm assuming the one provided with the eval board is not the right one?

Thank you.

Stephane

ELOG V3.1.4-80633ba