DRS4 Forum
  DRS4 Discussion Forum  Not logged in ELOG logo
Entry  Tue Feb 27 16:34:26 2018, Steven Block, DRS4 Dead times 6x
    Reply  Tue Feb 27 17:04:12 2018, Stefan Ritt, DRS4 Dead times 
       Reply  Tue Feb 27 18:04:18 2018, Steven Block, DRS4 Dead times 
          Reply  Tue Feb 27 18:12:32 2018, Stefan Ritt, DRS4 Dead times 
Message ID: 661     Entry time: Tue Feb 27 18:04:18 2018     In reply to: 660     Reply to this: 662
Author: Steven Block 
Subject: DRS4 Dead times 

That is extremely helpful! Many thanks. One more question; If I were to take inputs from 2 channels at once, would that scale the dead time to 64us using your example? 


Stefan Ritt wrote:

XML is very slow to write, and you are probably limited by that. Switch to binary mode, which is much faster. You will see in the end a maximum rate of ~500 Hz, and thus a dead time of 2ms, independent of the sampling speed. Note that you have only an evaluation board, which is optimized for ease of use. If you develop your own electronics, and do optimized readout, you can bring the deadtime down to 30ns x number of samples + 2us, or 32us if you read 1024 values from one channel.


Steven Block wrote:

Hello All,

I am currently trying to figure out how to properly characterize the dead time of the DRS4 board. My most recent experiment to try and answer this question involved using an external trigger that can range from 1Hz to 2MHz. I fed this trigger into the DRS4 and collected 1000 samples with no input to any channels. I repeated this across the range of my external trigger by a factor of ten [10Hz, 100Hz, 1kHz...etc]. After I had saved these runs in XML format, I looked at the difference between timestamps on the events. Attached are my findings. Can someone offer an explanation for the periodic peaks? I am new to the DRS4 and don't really understand how it works. My guess is that there is a buffer that has to be emptied every so often, but if so, the buffer emptying time varies with the frequency of the trigger. I would ideally like to be able to know the relation of the dead time to a particular setting I change on the DRS4 such as locking the sampling speed or changing external trigger frequency. 





ELOG V3.1.4-80633ba