Thanks a lot Stefan,
I asked if it is possible, in general, to create a connection and automatically fill in the tables of a report, or export the data into excell tables to then be connected to the report, having in our case about 24 process tables to be filled in with data or validation, for each report. If the compilation is not automatic, after having compiled the elog in each phase of the processing, the manifacturing report will then have to be compiled manually.
We use elog, having already used it in MEG We must then compulsorily also make manufacturing and test reports. The expected space-type documentation format for these documents is in word.
Below is a small example of a test table, with just a few steps.
Thanks again
Manuela
|
POWER INTERFACE VERIFICATION TEST
|
|
STEP
|
Description
|
Expected Value
|
Measured value
|
Remarks
|
-
|
Power-On Ixxxx
|
|
|
|
-
|
Test communications with ...
|
|
|
|
-
|
Command xxxx to switch-on the value ….V DC/DC
|
|
|
|
-
|
Configure a multimeter to measure voltage
|
|
|
|
-
|
Use the multimeter to check ..V interface. Connect multimeter positive prove to pin x, and negative prove to pin y of yyyy connector
|
Volts: x.xV ≤ ___ ≤ y.yV
|
|
|
-
|
Repeat operation between pins z and q of …
|
Volts: 5. 097V ≤ ______ ≤ 5.252V
|
|
|
-
|
Command xxxx to switch-on the ..V DC/DC
|
|
|
|
-
|
Use the multimeter to check ..V interface. Connect multimeter positive prove to pin xx, and negative prove to pin yy of yyyy connector
|
Volts: x.x V ≤ ______ ≤ y.y V
|
|
|
-
|
Power-Off xxx
|
|
|
|
-
|
Re-connect harness to zzzz through yyyy connector
|
|
|
|
-
|
Power-On xxx
|
|
|
|
-
|
Verify ..V input voltage. Check final voltage
|
Final Volts @ ..V: x.x V ≤ __ ≤ 5y.yV
|
|
|
-
|
Verify ..V power consumption
|
Consumption @ ..V: x.x< _ < y.y W
|
|
|
-
|
|
|
|
|
| Stefan Ritt wrote: |
|
You can just copy-and-paste an elog entry into Word. I tested it here wiht a simple table:
Did a copy-and-paste to Word, and got the thing below.
Best,
Stefan
| Manuela Rigano wrote: |
|
HI,
Is there a way to export the ELOG entries to a file like Microsoft Word?
For ECSS-type documents for space missions, I have to report the data that we enter in the ELOG in a Manufacturing Report, foreseen for ECSS, in word format. It's possible to do it?
The data has to go into tables, inserted in the world file, called "as run procedure".
Is it possible to connect the elog to a report template so that it automatically generates the manufacturing report? Or link the tables placed in it so that they are automatically filled in?
Thank you so much
Manuela
|
|
|