I'm using Kerberos and SSL and experience problems with individual setting of "Login user =" for different logbooks.
Sometimes (not every time, but most times) the server crashes under the following condition:
When I login at one logbook and then change to a logbook, that has a restricted "Login user" list with my login
name not in it. It created the following GDB output:

Program received signal SIGSEGV, Segmentation fault.
show_elog_list (lbs=0x916b768, past_n=0, last_n=0, page_n=0, default_page=1, info=0x0) at src/elogd.c:19793
19793         message_id = msg_list[index].lbs->el_index[msg_list[index].index].message_id;

Expected behaviour would be to show me the login page with the error message:
"you don't have access to this logbook".
This message is never shown for the attached configuration file.
If I remove the "Guest" commands for logbook "TestB" then elogd behaves properly.

For the moment I've just disabled "Login user" settings.

Regards
Andreas

In the summary view, it seems that the text is truncated at the first "<" character. See https://lblogbook.cern.ch/Shift/48812 for a simple entry, then use the 'list' command to see that only a very small part is displayed.

That's a feature

In the summary view, I cannot use any HTML code, since it will screw up the table layout. Therefore elog searches for any "<" and ">" pairs and removes the text in between. In principle one could do a better job, but I do not want to write a complete HTML interpreter just for that purpose. 

 Well, this is a choice. But if the encoding of the entry is 'plain', you could just avoid checking for embeded HTML. We use the summary view constantly for our main experiment logbook. Thanks anyway.

Ok, I fixed that in revision 2442. 

When I run a mirror server and both logbooks using SSL/KRB5 then the cron job causes a segmentation fault.

I haven't tried to check it with a simple configuration yet.
My set-up: two elogd on same server, one running "german" on port 444, the other "english" on port 445.
Both are behind an apache webserver configured reverse proxy, to hide the ports for external access.
I'll try to reproduce the fault with a "minimal configuration" soon and report again.


Debug output from GDB:

run -x -c /usr/local/elog/elogd_en.cfg
Starting program: /opt/elog-2.9.0/elog/elogd -x -c /usr/local/elog/elogd_en.cfg
elogd 2.9.0 built May 30 2011, 11:14:32 revision 2414
File "/var/run/elogd.pid" exists, using "/var/run/elogd.pid.445" instead.
Falling back to default group "elog"
Falling back to default user "elog"
User "elog" not found
Falling back to default user "nobody"
FCKedit detected
Falling back to default group "elog"
Falling back to default user "elog"
User "elog" not found
Falling back to default user "nobody"
ImageMagick detected
Indexing logbooks ... done
SSLServer listening on port 445 ...

Program received signal SIGSEGV, Segmentation fault.
0x0030b7b5 in SSL_write () from /lib/libssl.so.6