email notification authentication failed, posted by Xuan Wu on Fri Nov 13 11:26:12 2015
|
Hi All,
I got into trouble setting up the automated email notification.
elog.cfg: |
resending information confirmation box after refresh interval, posted by Ken Ludington on Mon Nov 16 20:42:15 2015 
|
After submitting a new post, if the page is left completely alone,, it will after a few minutes prompt that the page needs to resend information.
This is the same prompt you'd get if you attempt to refresh a page that had session variables passsed to it. Example is attached.
|
Re: resending information confirmation box after refresh interval, posted by Stefan Ritt on Tue Nov 17 08:33:15 2015
|
Start with the demo example configuration, add one line after the other from your config, and figure out which is the offending statement in your config,
then post a minimal configuration here which triggers the problem.
Ken |
|
Re: Paste figure from Clipboard, CKEditor 4.5.1 and Firefox 42, posted by Simon Däster on Mon Nov 23 10:32:37 2015
|
| Updating CKeditor did work, thanks for the tip. |
Prefill attributes for new post, posted by Johan Forsberg on Tue Jan 12 11:35:55 2016
|
Hi all,
I have a use case for ELOG where I need to be able to "prefill" some attributes in the "cmd=new" form, based on the URL.
To illustrate, imagine a link that takes the user directly to the form for creating a new post, with the "Subsystem" attribute already |
|
Re: Prefill attributes for new post, posted by Andreas Luedeke on Tue Jan 12 11:48:57 2016
|
Hi Johan,
yes, it is possible. And you were actually very close :-)
In order to pass preset-parameters within a URL, you
just need to prefix the fieldname with a "p". In your example, you would write "...&pSubsystems=Vacuum".
Here is
an example for the Linux Demo logbook:
https://midas.psi.ch/elogs/Linux+Demo/?cmd=New&pAuthor=Santa+Claus&pSubject=Christmas+Presents&pType=Problem+Fixed&pCategory=Hardware
This |
|
Re: Prefill attributes for new post, posted by Stefan Ritt on Tue Jan 12 11:50:22 2016
|
Put a "p" in front of the attribute, like "&pSubsystem=Vacuum". This is kind of an undocumented feature just for the experts
;-)
Johan |
|
Re: Prefill attributes for new post, posted by Johan Forsberg on Tue Jan 12 14:05:55 2016
|
Wow, than you both for the quick response! I agree it's quite a hidden gem, but the most important thing is that it works, thanks!
Stefan
Ritt wrote:
Put a "p" in front of the attribute, like "&pSubsystem=Vacuum". |