Hello,

Is there a way to include some attribute fields in the e-mail from eLog, but not all?

E.g, if you have the following:
Attributes = TA, Endret, UA, Pri, Status, Oppdragsgiver, EpostTil, EpostIKT, Tittel

Then you get the heading:
Logbook             : 
TA                  : 
Endret              : 
UA                  : 
Pri                 : 
Status              : 
Oppdragsgiver       : 
EpostTil            : 
EpostIKT            : 
Tittel              : 

(removed the attribute data),

But I would like to send out only:
UA                  : 
Pri                 : 
Status              : 
Oppdragsgiver       : 
EpostTil            : 
Tittel              : 

Any way to do this in the current version?

And perhaps change the order too... I'm asking for much perhaps?

Best regards
Michael

> I added the option "Email attributes = <list>" for that. So you can specify
> 
> Email attributes = UA, Pri, Status, Oppdragsgiver, EpostTil, Tittel
> 
> which also sets the order of the attributes. The cange is in CVS.

Nice!

Thanks Stefan, I will test it when I'm back from my holiday. Only problem is that this change is also in a
beta version of elog (more "beta" than usual)

Perhaps it is not in this state when I'm back :)

have a nice holiday

Best regards
Michael

> 
> > I added the option "Email attributes = <list>" for that. So you can specify
> > 
> > Email attributes = UA, Pri, Status, Oppdragsgiver, EpostTil, Tittel
> > 
> > which also sets the order of the attributes. The cange is in CVS.

Hello Stefan,

Tested the 2.6.0-beta4, and it sort of works. config parameter:
Email attributes = Tittel,Status

gives the mail:

Logbook             : work
Tittel              : Test
Status              : Åpen

Logbook URL         : http://xxxxxxxxxxxxxxxx/work/904

---

Is there a way to remove Logbook field (and perhaps Logbook URL if I want?)

Best regards
Michael

Hi,

I am new to elog so please bear with me if this sounds like a stupid
question... 

I would like to run elogd under Apache because I don't want to open another
port (eg. 8080) on the firewall for incoming http traffic. I followed the
special instructions for that sort of setup but the user logon screen always
comes up again, even after using a valid username/password.

I am testing on a Redhat 7.2 based distribution (called SME server) in a
test domain (tuxhome.co.nz). 
"Apache modules mod_proxy.c and mod_alias.c are activated", Yes.
There seems to be a problem here with the Apache Redirect statement. When I
try with
Redirect permanent /elog http://www.tuxhome.co.nz/elog/
ProxyPass /elog/ http://www.tuxhome.co.nz:8080/
Mozilla responds "Redirection limit for this URL exceeded" and IE6 says
"cannot find server or DNS error" so I have commented out the redirect
statement for now.
I might misunderstand the required URL statement in elogd.cfg 
"URL = http://your.proxy.host/subdir/" ?
which I understand it would have to be 
URL = http://www.tuxhome.co.nz/elog/ for my above example?

Maybe someone could help me with an example that includes all 3 of the
statements together, the redirect + proxypass from httpd.conf plus the URL
from elogd.conf?
Thanks for any help.

Michael