DRS4 Forum
  DRS4 Discussion Forum  Not logged in ELOG logo
Entry  Thu Dec 13 12:03:29 2012, Evgeni, DRS-4 trigger 
    Reply  Thu Dec 13 12:14:35 2012, Stefan Ritt, DRS-4 trigger 
       Reply  Thu Dec 13 19:49:47 2012, Evgeni, DRS-4 trigger 
          Reply  Fri Dec 14 08:42:53 2012, Stefan Ritt, DRS-4 trigger DRSOsc.png
             Reply  Fri Dec 14 10:07:54 2012, Evgeni, DRS-4 trigger 
    Reply  Fri Dec 14 10:07:14 2012, Evgeni, DRS-4 trigger 
Message ID: 207     Entry time: Thu Dec 13 19:49:47 2012     In reply to: 206     Reply to this: 208
Author: Evgeni 
Subject: DRS-4 trigger 

 

Stefan Ritt wrote:

 

Evgeni wrote:

How to configure DRS oscilloscope for the oscillations with an amplitude greater than the value of the exposed
in the trigger (internal). 

 

Sorry, I don't understand that question. The DRS4 Evaluation board input signal range is 1V. If you have larger signals, you have to attenuante them externally.

/Stefan 

 

 

Can I adjust the internal trigger DRS oscilloscope for signal extraction 0.5 volts (for example) from any of the four channels. In our case, there is a lot of noise with low amplitude, which must be removed during the registration. We need to record the individual pulses of higher amplitude than the noise. So we want to use the internal trigger DRS oscilloscope to cut this noise by setting up its threshold amplitude noise.

ELOG V3.1.4-80633ba