DRS4 Forum
  DRS4 Discussion Forum  Not logged in ELOG logo
Entry  Wed Oct 26 21:15:35 2016, Alexey Lubinets, Problems with DRS command line 
    Reply  Thu Oct 27 08:29:26 2016, Stefan Ritt, Problems with DRS command line 
       Reply  Fri Oct 28 15:02:18 2016, Simon Mendisch, Problems with DRS command line 
          Reply  Fri Oct 28 15:51:59 2016, Stefan Ritt, Problems with DRS command line 
Message ID: 550     Entry time: Thu Oct 27 08:29:26 2016     In reply to: 549     Reply to this: 551
Author: Stefan Ritt 
Subject: Problems with DRS command line 

Alexey Lubinets wrote:
Hello, everybody

I have installed the software for the DRS4 Evaluation Board.
When I run the DRS Oscilloscope, it works OK (at least, my computer "knows", that the board is connected). But when I run the DRS Command Line Interface, it writes "USB successfully scanned, but no boards found
No DRS boards found".
How can I manage with this problem? The drivers for the DRS Evaluation Board are installed.

Regards, Alexey Lubinets


You are the first one describing this problem (out of ~200 people), so I guess the problem must be on your side. Have you made sure to start the DRS oscilloscope and the Command Line Interface not at the same time? Only one program can access the board at a given time. Have you tried disconnecting and re-connecting the board?

Stefan
ELOG V3.1.5-fe60aaf