There are two locations where 'Subject' is shown, the list display and the individual message display. I guess you mean the first one. 

In that case, you can modify the CSS styel sheet 'elog.css' and add following statement to the classes list2 and list2h:

.list2 {
   ...
   white-space: nowrap;
}  

.list2h {
   ...
   white-space: nowrap;
}  

Certain characters contained in the 'Subject' will cause the text to split into multiple lines .

For example if  I enter "My Subject" in the 'Subject' field it is displayed as

My

Subject

If I enter "My_Subject" it is displayed as 

My_Subject

Is there any way to change this so no line breaks are created ?

Thanks a lot Stefan,

I asked if it is possible, in general, to create a connection and automatically fill in the tables of a report, or export the data into excell tables to then be connected to the report, having in our case about 24 process tables to be filled in with data or validation, for each report. If the compilation is not automatic, after having compiled the elog in each phase of the processing, the manifacturing report will then have to be compiled manually.

We use elog, having already used it in MEG We must then compulsorily also make manufacturing  and test reports. The expected space-type documentation format for these documents is in word.

Below is a small example of a test table, with just a few steps.

Thanks again

Manuela

POWER INTERFACE VERIFICATION TEST

STEP

Description

Expected Value

Measured value

Remarks

Power-On Ixxxx

Test communications with ...

Command xxxx to switch-on the  value ….V DC/DC

Configure a multimeter to measure voltage

Use the multimeter to check ..V interface. Connect multimeter positive prove to pin x, and negative prove to pin y of yyyy connector

Volts:  x.xV ≤ ___ ≤ y.yV

Repeat operation between pins z and q of …

Volts:  5. 097V ≤ ______ ≤ 5.252V

Command xxxx to switch-on the ..V DC/DC

Use the multimeter to check ..V interface. Connect multimeter positive prove to pin xx, and negative prove to pin yy of yyyy connector

Volts:  x.x V ≤ ______ ≤ y.y V

Power-Off xxx

Re-connect harness to zzzz through yyyy connector

Power-On xxx

Verify ..V input voltage. Check final voltage

Final Volts @ ..V:  x.x V ≤ __ ≤ 5y.yV

Verify ..V power consumption

Consumption @ ..V: x.x< _ < y.y W

You can just copy-and-paste an elog entry into Word. I tested it here wiht a simple table:

Did a copy-and-paste to Word, and got the thing below.

Best,
Stefan

HI,

Is there a way to export the ELOG entries to a file like Microsoft Word?
For ECSS-type documents for space missions, I have to report the data that we enter in the ELOG in a Manufacturing Report, foreseen for ECSS, in word format. It's possible to do it?
The data has to go into tables, inserted in the world file, called "as run procedure".
Is it possible to connect the elog to a report template so that it automatically generates the manufacturing report? Or link the tables placed in it so that they are automatically filled in?

Thank you so much
Manuela