Re: Elog & SSL Export to CSV , Problem, posted by soren poulsen on Sun Nov 8 23:25:25 2009
|
Chuck Brost wrote:
|
|
Re: Elog & SSL Export to CSV , Problem, posted by Stefan Ritt on Tue Nov 10 14:56:07 2009
|
Chuck Brost wrote:
Stefan, would it be possible to make the following change so that the document is not cached and at |
|
Re: Edit of multiple posts, posted by Andreas Luedeke on Tue Oct 15 10:37:29 2019
|
I use editing of multiple entries frequently and it works fine for me.
To understand your problem I would suggest that you try a minimal configuration. If you have a test logbook with just one or two fields and it
still does not work, then post the config here that people can reproduce your problem - and hopefully find a fix. |
|
Re: Edit of multiple posts, posted by Finn Junker on Thu Oct 17 14:57:25 2019
|
Hello Andreas
OK, I did install a version of ELOG with a minimum of settings and the edit of multiple settings works fine. I've tracked the issue to "Locked
Attributes = Bruger". |
|
Re: Edit of multiple posts, posted by Andreas Luedeke on Fri Oct 18 08:50:27 2019
|
Hi Finn,
I don't know if this was intended, but at least I know a possible solution: with the command
"Show
Attributes Edit = "
you can limit the attribute list shown in the edit form to those that are not |
Re: Edit of multiple posts, posted by Finn Junker on Fri Oct 18 09:40:54 2019 
|
Hello Andreas
Show Attributes Edit = xxx, limits the attributes shown when editing but when you submit you get the error
Error: Attribute Bruger not supplied. |
|
Re: Edit of multiple posts, posted by Andreas Luedeke on Fri Oct 18 23:22:50 2019
|
I'm sorry, apparently my tip was not clear: you should use "Show Attributes Edit = " to NOT SHOW any of your locked attributes.
It
is just a guess: if the attribute is not shown in your edit form, it will not complain about it when you submit the form.
Did you try that?
Cheers,
Andreas
Finn |
|
Re: Edit of multiple posts, posted by Finn Junker on Mon Oct 21 10:46:43 2019
|
Hello Andres
Or maybe my reply was unclear :-), but i did use the "Show Attributes Edit" the way you meant to not show attribute BRUGER
and when i do that i get: |